Avoid placing the camera within close proximity to other Wi-Fi devices to avoid signal interference during the setup process. Note: Make sure the camera is within 3 to 6 feet of your Arlo SmartHub or Base Station during the setup process.

Arlo will begin looking for your camera:.

When the LED on the camera is blinking Blue, tap Continue.

Press the SYNC button on the camera for about two seconds and then release the button.

Insert the batteries as shown and close the battery door. Unlock the battery compartment by sliding and holding the latch. If you have trouble connected the SmartHub or Base Station, visit: Arlo can't discover my SmartHub or Base Station during installation what do I do? Plug the AC adapter into the wall outlet, make sure the lights on the SmartHub or Base Station come on, and tap Continue. Plug the Ethernet Cable into your SmartHub or Base Station and tap Continue.

Note: If a SmartHub or Base Station is not installed, tap Add New SmartHub.

Select an Arlo SmartHub or Arlo Base Station.

On the Select your Arlo model screen, tap Others.

On the Select your Arlo device screen, tap Cameras.

Scroll down to the bottom of the screen and tap Add New Device.

To setup other Arlo camera models, visit: How to set up Arlo Cameras If you are setting up multiple cameras, only sync one camera at a time.

Note: To complete the setup process, you will need an Arlo SmartHub or Base Station. The following instructions apply to setting up the original Arlo Wire-Free Camera (VMC3030).

Arto instaling